GoMax

PK80 80CC Complete Bicycle Engine Kit with CNC Head and MZ65 Clone Pipe

Name: PK80 80CC Complete Bicycle Engine Kit with CNC Head and MZ65 Clone Pipe
Brand: GoMax
SKU: PK80-36T-CNC-F
Price: 199.0 USD
Availability: InStock

PK80 80CC Complete Bicycle Engine Kit with CNC Head and MZ65 Clone Pipe

$199.00 USD

Sale Sold out

Shipping calculated at checkout.

Product variants

Quantity

High Performance Super PK80 2 Stroke 80CC Engine Kit.

Square CNC Head And MZ65 clone Pipe

Triple 40; 40mm Intake, 40mm Stroke, 40mm Front Mount

36 Tooth Rear Sprocket comes standard, 44 Tooth is available if requested at checkout!

Upgraded Larger SPEED Carburetor

NEW Chain Tensioner with 4 bolts

Max. Power(hp/rpm): 80cc: 3.5HP/6000

Bicycle Engine Kits including as follows parts:

1). gas motor

2). 2L Black Fuel Tank

3). Chromed Exhaust Pipe

4). Chromed 9 hole, 44 Tooth Sprocket 1pc, 36 tooth available please send message.

5). Clutch Lever

6). Throttle With Kill Switch

7). 415 Heavy Chain

8).Sprocket Install Kit

9).Chain Guard

10).Clutch Cable & Accelerator Cable

11).Front U mount

12). 3 Prong Spark Plug

13).CDI Ignition

14). Spark Plug Tool

15): NEW SPEED Carburetor

16): NEW chain tensioner with 4 bolts

Shipping to AK, Hi and Puerto Rico will incur additional charges.

General Information First Few Rides go Slow!!!

Obey all traffic regulations. Always wear a helmet while riding. Remember that you are riding a motorized bicycle and other traffic may not be able to see you. Never operate your motorized bicycle on a pedestrian through way or sidewalk while the engine is operating. Never operate your motorized bicycle in an unsafe manner. Check local and state laws before riding on streets. WARNING! ALWAYS wear a helmet while riding.

Motorized Bicycle Starting and Operating instructions:

1. IMPORTANT: PLEASE READ THIS: Gas and Oil Mixture for Fuel ratio

The engine is a 2 cycle design, therefore, a gasoline/oil mixture is necessary. During the break-in period (1^st 2 gallons of fuel), Break in ratio for 80cc is 8 oz. 2 Cycle Oil per Gallon. After the break-in period, 4 to 6 oz. per Gal. depending on use. Use of Pre-Mix or Synthetic Oil is not recommended!!! I useWalmart Super Tech 2-Cycle @ $13.84 per Gallon.. Before riding and on a periodic basis continually check Nuts and Bolts for tightness. Engine vibration can loosen. âLockTightâ is recommended.

*NOTE: Use only 2 Stroke Oil to insure proper engine lubrication.

2. If the rpm needs adjusting, turn the idle adjust screw (left side of carburetor) in or out slowly to obtain the proper idle speed of about 1400 rpm +/- 100 rpm. To correctly break in the engine in do not exceed 15 mph or 30 min. continual running for the first 50 miles during engine break in. Engine will develop more power after break in.